Variable compression ratio

Variable compression ratio

Variable compression ratio is the technology to adjust internal combustion engine cylinder compression ratios on the fly. This is done to increase fuel efficiency while under varying loads. Higher loads require lower ratios to be more efficient and vice versa. Variable compression engines allow for the volume above the piston at 'Top dead centre' to be changed. For automotive use this needs to be done dynamically in response to the load and driving demands.

Why is it desirable

Petrol engines have a limit on the maximum pressure during the compression stroke, after which the fuel/air mixture detonates rather than burns. To achieve higher power outputs at the same speed, more fuel must be burnt and therefore more air is needed. To achieve this, turbochargers or superchargers are used to increase the inlet pressure. This would result in detonation of the fuel/air mixture unless the compression ratio was decreased, ie the volume above the piston made greater. This can be done to greater or lesser extent with massive increases in power being possible. The down side of this is that under light loading, the engine can lack power and torque. The solution is to be able to vary the inlet pressure and adjust the compression ratio to suit. This gives the best of both worlds, a small efficient engine that behaves exactly like a modern family car engine but turns into a highly tuned one on demand.

Variable compression ratio is becoming increasingly desirable as oil prices increase and car buyers have an increased interest in fuel economy.

The cylinder head can be altered by using a hydraulic system which is connected to the crank shaft and responds according to the load and acceleration required.

Production

Variable compression engines have existed for decades but only in laboratories for the purposes of studying combustion processes. These designs usually have a second adjustable piston set in the head opposing the working piston. (very much like model aircraft 'Diesel' engines) Variable compression engines have been highly desirable but technically unobtainable for production vehicles due to the mechanical complexity and difficulty of controlling all of the parameters. The advances in low cost microcontrollers and a wealth of experience in their application to engine management now makes the control possible. SAAB introduced a variable compression to the world at the Geneva motor show in 2000 but has yet to reach production as of 2008 The design consisted of a monobloc head, which contained all of the valve gear, and the crankshaft/crankcase assembly. These parts were connected together by a pivot which allowed 4 degrees of movement controlled by a hydraulic actuator. This mechanism allows the distance between the crankshaft centre line and the cylinder crown to be varied.A supercharger was chosen in preference to a turbocharger to achieve the necessary response time and high boost pressure.

ee also

* Continuously variable transmission
* Variable valve timing
* Diesotto

References

* [http://www.saabnet.com/tsn/press/000318.html Saab press release]
* [http://www.sae.org/automag/techbriefs_05-00/03.htm Automotive engineering international article]


Wikimedia Foundation. 2010.

Игры ⚽ Нужен реферат?

Look at other dictionaries:

  • Compression ratio — For compression ratio in data compression, see data compression ratio. The compression ratio of an internal combustion engine or external combustion engine is a value that represents the ratio of the volume of its combustion chamber from its… …   Wikipedia

  • Saab Variable Compression engine — The Saab Variable Compression engine was a development project of Saab Automobile, for which it won an award both in 2000 and 2001.In a normal internal combustion engine, because cylinder bore diameter, piston stroke length and combustion chamber …   Wikipedia

  • Homogeneous charge compression ignition — Thermodynamics …   Wikipedia

  • Homogeneous Charge Compression Ignition — Homogeneous Charge Compression Ignition, or HCCI, is a form of internal combustion in which well mixed fuel and oxidizer (typically air) are compressed to the point of auto ignition. As in other forms of combustion, this exothermic reaction… …   Wikipedia

  • Variable bitrate — (VBR) is a term used in telecommunications and computing that relates to the bitrate used in sound or video encoding. As opposed to constant bitrate (CBR), VBR files vary the amount of output data per time segment. VBR allows a higher bitrate… …   Wikipedia

  • Dynamic range compression — This article is about a process that intentionally reduces the dynamic range of audio signals. For similar reductions caused by circuit imperfections, see Gain compression. For processes that reduce the size of digital audio files, see Audio… …   Wikipedia

  • Stroke ratio — In a reciprocating piston engine, the stroke ratio, defined by either bore/stroke ratio or stroke/bore ratio, is a term which is used to describe the ratio between the diameter of the cylinder bore and the length of the piston stroke within its… …   Wikipedia

  • Data compression — Source coding redirects here. For the term in computer programming, see Source code. In computer science and information theory, data compression, source coding or bit rate reduction is the process of encoding information using fewer bits than… …   Wikipedia

  • S3 Texture Compression — (S3TC) (sometimes also called DXTn or DXTC) is a group of related lossy texture compression algorithms originally developed by Iourcha et al. of S3 Graphics, Ltd. [1] for use in their Savage 3D computer graphics accelerator. The method of… …   Wikipedia

  • Continuously variable transmission — Transmission types Manual Sequential manual Non synchronous Preselector Automatic Manumatic Semi automatic Electrohydraulic Dual …   Wikipedia

Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”