Key telephone system

Key telephone system

A key system or key telephone system is a multiline telephone system typically used in small office environments.

Key systems are noted for their expandability and having individual line selection buttons for each connected phone line, however some features of a private branch exchange such as dialable intercoms may also commonly be present.

Key systems can be built using three principal architectures:

* Electromechanical shared-control
* Electronic shared-control
* Independent keysets

Electromechanical shared-control key systems

Before the advent of large-scale integrated circuits, key systems were typically built out of electromechanical components (relays) as were larger telephone switching systems.

The systems marketed in North America as the 1A, 6A, 1A1 and the 1A2 Key System were entirely typical and sold for many decades. The 1A family of Western Electric Company (WECo) key telephone units (KTUs) were in use in the 1950s. 1A equipment was primitive and required at least two KTUs per line; one for line termination and one for station (telephone instrument) termination. The telephone instrument commonly used by 1A systems was the WECo 300-series telephone. In the 1960s, 1A1 key systems simplified wiring with a single KTU for both line and station termination, and increased the features available to the users. As the 1A1 systems became commonplace, requirements for intercom features increased. The original intercom KTUs, WECo Model 207, were wired for a single talk link, that is, a single conversation on the intercom at a time. The WECo 6A dial intercom system provided two talk links and was often installed as the dial intercom in a 1A1 or 1A2 key system. Unfortunately, the 6A systems were very complex and prone to problems. They were also very expensive and never came much into favor. The advent of 1A2 technology in the 1970s tremendously simplified key system set up and maintenance. These continued to be used throughout the 1980s, though the arrival of electronic key systems with their easier installation and greater features signaled the end of all electromechanical key systems.

Two obscure key systems were used at airports for air traffic control communications, the 102 and 302 key systems. These were uniquely designed for communications between the air traffic control tower and radar approach control (RAPCON) or ground control approach (GCA), and included radio line connections.

Automatic Electric Company also sold a family of key telephone equipment, but it never gained the widespread use enjoyed by Western Electric equipment.

Electronic shared-control systems

With the advent of LSI ICs, the same architecture could be implemented much less expensively than was possible using relays. In addition, it was possible to eliminate the many-wire cabling and replace it with much simpler cable similar to (or even identical to) that used by non-key systems. One of the most recognized such systems is the AT&T Merlin.

Additionally, these more modern systems allowed a vast set of features including:

* Answering machine functions
* Remote supervision of the entire system
* Automatic call accounting
* Speed dialing
* Caller ID
* Station-specific limitations (such as no long distance access or no paging)
* Selection of signalling sounds

Features could be added or modified simply using software, allowing easy customization of these systems. The stations were easier to maintain than the previous electromechanical key systems, as they used efficient LEDs instead of incandescent light bulbs for line status indication.

Independent keysets

LSI also allowed smaller systems to distribute the control (and features) into individual telephone sets that don't require any single shared control unit. Generally, these systems are used with a relatively few telephone sets and it is often more difficult to keep the feature set (such as speed-dialing numbers) in synchrony between the various sets.

PBX systems

The line between the largest key systems and full PBX systems is blurred. In the 1A2 days, the line was clear: 1A2 systems did not allow the sharing of anonymous "trunk" lines and PBX systems did. Modern key systems blur this distinction by often allowing this feature.

Hybrid keyphone systems

Into the 21st century, the distinction between key systems and PBX has become increasingly confusing. Early electronic key systems used dedicated handsets which displayed and allowed access to all connected PSTN lines and stations. , analog handsets (in addition to its own dedicated handsets - usually digital) as well as a raft of features more traditionally found on larger PBX systems. The fact that they support both analog and digital signalling types gives rise to the "Hybrid" designation.

The modern key system is usually fully digital (although analog variants persist) and some systems embrace VOIP. Indeed, key systems now can be considered to have left their humble roots and become small PBXes. Effectively, the aspects that separate a PBX from a key system are the amount, scope and complexity of the features and facilities offered.

ee also

RJ21


Wikimedia Foundation. 2010.

Игры ⚽ Поможем сделать НИР

Look at other dictionaries:

  • key telephone system —    A system that provides direct selection of an outside line from a multiline telephone set; such functions as line holding and intercommunications are selected at the instrument. Visual indications are given on the status of each line… …   IT glossary of terms, acronyms and abbreviations

  • Business telephone system — Early model 464G Western Electric key telephone set A business telephone system is any of a range of a multiline telephone systems typically used in business environments, encompassing systems ranging from small key systems to large scale private …   Wikipedia

  • Key system — can refer to the following:*Key telephone system communication *Key System Defunct transportation system in the San Francisco Bay Area *KeY System a software verification tool. *Cryptosystem using a Cryptographic key …   Wikipedia

  • Telephone plug — A telephone plug is a plug which allows a telephone to connect to the local telephone network. It plugs into a socket or jack fixed to the wall or baseboard. The standard for telephone plugs varies from country to country though the RJ11 has… …   Wikipedia

  • key service unit —    (KSU)    The main operating unit of a key telephone system …   IT glossary of terms, acronyms and abbreviations

  • telephone — telephoner, n. /tel euh fohn /, n., v., telephoned, telephoning. n. 1. an apparatus, system, or process for transmission of sound or speech to a distant point, esp. by an electric device. v.t. 2. to speak to or summon (a person) by telephone. 3.… …   Universalium

  • Telephone — The telephone (from the el. τῆλε, tēle , far and φωνή, phōnē , voice ) is a telecommunications device that is used to transmit and receive sound (most commonly speech), usually two people conversing but occasionally three or more. It is one of… …   Wikipedia

  • Telephone tapping — Wiretap redirects here. For the radio program, see WireTap (radio program). Telephone tapping (also wire tapping or wiretapping in American English) is the monitoring of telephone and Internet conversations by a third party, often by covert means …   Wikipedia

  • 1A2 Key System — The 1A2 Key System is an analog multiline business key telephone system. Unlike more modern multiline systems, every telephone line serving a particular phone is wired into that phone, and electromechanical switches (the keys ) switch the lines… …   Wikipedia

  • Multi-Line Extension telephone — This article refers to a specific series of historic telephones. For multi line phone systems in general, see private branch exchange or key telephone system. A Multi Line Extension, or MLX telephone, is a no longer manufactured series of digital …   Wikipedia

Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”