Mindbender (Galaxyland)

Mindbender (Galaxyland)
Mindbender
Mindbender.jpg
The Mindbender
Location Galaxyland
Status Operating
Opened 1985
Type Steel
Manufacturer Anton Schwarzkopf
Designer Werner Stengel
Track layout Indoor
Lift/launch system Tire Drive lift hill
Height 145 ft (44 m)
Drop 127 ft (39 m)
Length 4,198 ft (1,280 m)
Max speed 60 mph (97 km/h)
Inversions 3
Duration 1:13
Capacity 430 riders per hour
Max G force 6.8 G according to schwarzkopf.coaster.net

or 5.2 G acc. to RCDB

Mindbender at RCDB
Pictures of Mindbender at RCDB
Amusement Parks Portal

The Mindbender is the world's largest indoor triple loop roller coaster. It is located in Galaxyland Amusement Park, a major attraction inside West Edmonton Mall, in Edmonton, Alberta, Canada. Galaxyland is the second largest indoor amusement park in the world, and West Edmonton Mall is the largest mall in North America.

Contents

Layout

Mindbender was designed by Germany's Werner Stengel and built by Anton Schwarzkopf. It was inspired by this team's previous design, Dreier Looping, a portable coaster that travelled the German funfair circuit, before being sold to a succession of amusement parks in Malaysia, Great Britain, and most recently, Mexico. Mindbender is a pseudo mirror-image of Dreier Looping, and is slightly taller, with additional helices at the end of the ride. Mindbender features shorter trains, with three pilot cars, whereas Dreier Looping usually ran with five trailer cars and one pilot car, occasionally rising to seven-car trains at busy funfairs.

The ride's layout features many twisting drops, three vertical loops and a double upward helix finale. The ride twists underneath, in between and around its supports. It also goes underneath the "UFO Maze", (which has been removed to make way for a new roller coaster - Gerstlauer's Galaxy Orbiter), during the helix.

Often in high season, the last car on one of the trains is reversed, allowing guests to ride the roller coaster without being able to see where they are going.

Ride Experience

After boarding the Mindbender, riders put on a seatbelt and lap restraints. Also, the ride operator lowers large shoulder restraints over the riders. All of the restraints keep the riders firmly secured in the seat.

After ascending the curving wheel driven lift hill, the train descends a sharp, twisting left-hand drop (sometimes referred to as a Taver drop) that climbs up to the first of four stacked block brakes. The train negotiates a second left-hand drop that is immediately followed by two vertical loops. The aforementioned process happens yet again, but the height of the coaster is decreased and the next loop is a single one.

Upon completing the final loop, the coaster train shoots along a two-layered upward helix before running behind the Turbo Ride theatre and into the exit/entry area.

The ride length from the initial drop should normally range from one minute fifteen seconds to one minute eighteen seconds. Circuits times as little as 59 seconds are possible through extensive waxing of the track, and reduction in tension on the bogey wheels. This increase in speed is not usually permitted during public rides, as the forces on the riders becomes severe. During testing of the renovated trains in 1987, the maximum g-force of a normal run was measured on equipment bolted into the train at 5.5 G's, which occurs in the second loop.

1986 Crash

On the evening of June 14, 1986, after the yellow train (train #1) completed the second inverted loop, it encountered one of three areas of uplift before the third and final loop. Missing bolts on the left inside wheel assembly of the last car of the four car train caused the bogey assembly to disengage the track with a full load of riders. This caused the final car to fishtail wildly, disengaging the lap bars as it collided with support structures, thereby throwing off passengers and losing speed. The train entered the third and final inverted loop, but did not have the speed to complete the loop. The train stalled at the top, then slid backwards, crashing into a concrete pillar. Three people were killed during the accident and a fourth man was almost killed.

At the time of the accident the park was packed with people who were attending a concert. The ride had shut down twice, as the operator had heard a metallic noise from the train prior to the accident. Despite running the trains empty, the source of the problem could not be located by the maintenance staff, and the regular operation of the ride resumed until the accident occurred. With the stage located atop the jumping fountains, many had a horrific view as the band played and the coaster derailed. The Mindbender was immediately closed. An investigation and inquiry was launched that revealed that there were problems in the translation from German to English of operational and maintenance information from Schwarzkopf, the German coaster manufacturer. Additional issues with quality control were found as a result of the manufacturer going bankrupt during delivery of the ride, and portions of the ride being finished by the receiver of the firm.

The root cause of the accident stemmed from the means in which each six wheel bogie was affixed to the axle. The bogie pivoted horizontally on a vertical axle, which was in turn attached to the main axle which joined each pair of bogie assemblies. The means each bogie was affixed to the vertical axle was a cap plate, located just above the track rail (1/4" clearance) and secured with four hex head recessed cap screws. As the cap screws became loose, they rubbed on the rails and eventually snapped or fell out as they rubbed along the track, releasing the retaining plate. Once all four bolts came loose, the cap plate no longer affixed the bogey to the vertical axle, and at the next uplift area, the axle came out of the bogie and the last car of the train derailed.[1] Full details of the technical inquiry are found in the publication MALL COASTER INQUIRY (1987) The Alberta Government Labour Department, Alberta Labour Information Services, 10808 - 99 Avenue, Edmonton, Alberta Canada T5K 0G5

In addition, Mindbender crews in Canada had not been provided a special inspection order from the General Safety Services Division of Germany where the ride was manufactured. Cars were checked only by visual inspections, not by taking them out from service. Visual inspections alone would not have been adequate to determine if screws or bolts were loose due to the obscured area the bolts were located. It was discovered that one-quarter of all axle bolts on the trains were loose.[1] No safety check had been made through the German TÜV organization. In addition, the restraint systems were also criticised for being inadequate as contact with the pillars supporting the ride disengaged the lap bars.

When the Mindbender reopened seven months later, the trains were redesigned. Existing four car trains were converted to 3 car trains, each have four bogeys on two axles (front and rear). Anti-roll back "dogs" were added to prevent the train from rolling backwards during the initial lift. Seating capacity was reduced from 16 to 12 per train. The lap bar restraint was retained, but seat belts and a shoulder headrest were added for redundancy. The design of the vertical axle was changed so that the axle became a fixed part of the bogey, and the retaining bolt was moved to the top of the axle, where it is easily inspected. Finally, maintenance checks and scheduled maintenance downtimes were significantly increased. In the twenty years since the accident, the Mindbender has an excellent safety record.

Prior to the accident, the Mindbender had two yellow, two red, and two blue trains. After the accident, the original trains were sent to Germany for rebuild into the trains in use today. However, they returned only in red and blue colours, to ease the public perception of yellow trains which were featured in the media post-crash. Recently, the trains were repainted, and yellow colour has returned.

After the government inquiry, the damaged yellow train #1 was returned to the mall, along with other materials seized during the inquiry. The first three cars of train #1 were stored in the basement of the mall until later disposed of. The fourth car which derailed, was cut up by welders torch into small burned unrecognizable bits and disposed of. Train #1 was not reused, but occasionally scratches in the paint of the current vehicles, might reveal the identity of train #2, the second original yellow train.

Notes

  1. ^ http://www.ualberta.ca/ALUMNI/history/peopleh-o/88sumkulak.htm

External links


Wikimedia Foundation. 2010.

Игры ⚽ Поможем сделать НИР

Look at other dictionaries:

  • Mindbender — Mindbender(s) may refer to: In film and television: Mindbenders (film), a 2004 independent science fiction film Ken Russell inspired by the life of Uri Geller The Mind Benders (film), a 1962 film starring Dirk Bogarde Mindbender , an episode of X …   Wikipedia

  • Mindbender Unglück — Mindbender Daten Typ Stahl sitzend Kategorie Indoor Hersteller …   Deutsch Wikipedia

  • Mindbender — Daten Standort Galaxyland (Edmonton, Kanada) Typ …   Deutsch Wikipedia

  • Galaxyland — 53° 31′ 25″ N 113° 37′ 14″ W / 53.5236694444444, 113.620505555556 …   Wikipédia en Français

  • Galaxyland — Infobox Amusement park name = Galaxyland caption =Mindbender rollercoaster and UFO maze location = West Edmonton Mall, Edmonton, Alberta location2 = Canada location3 = flagicon|Canada opening date = 1985 closing date = previous names =… …   Wikipedia

  • Galaxyland — Die Mindbender Achterbahn Galaxyland Amusement Park ist der Name des größten Indoor Vergnügungsparks der Welt. Es befindet sich in der West Edmonton Mall im kanadischen Edmonton. Der auf einer Fläche von über 37.000 m² große Park bietet über 27… …   Deutsch Wikipedia

  • Anton Schwarzkopf — (1924–2001) was a prolific and very highly regarded German engineer of amusement rides, and founder of the Schwarzkopf Industries company, which built numerous rides and large roller coasters for both amusement parks and travelling… …   Wikipedia

  • Diffusion of technology in Canada — This article outlines the history of the diffusion or spread of technology in Canada. Technologies chosen for treatment here include, in rough order, transportation, communication, energy, materials, industry, public works, public services… …   Wikipedia

  • Liste von Stahlachterbahnen — Alphabetische Aufstellung von Stahlachterbahnen. Es sind derzeit 1929 Stahlachterbahnen weltweit in Betrieb. Diese Liste ist nicht vollständig und wird fortlaufend erweitert. Sie enthält alle derzeit in Deutschland betriebenen stationären… …   Deutsch Wikipedia

  • Mind Bender (Six Flags Over Georgia) — This article is about the roller coaster at Six Flags Over Georgia. For the roller coaster at West Edmonton Mall, see Mindbender (Galaxyland) . Mind Bender Mind Bender s s …   Wikipedia

Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”